Elgin Pelican P Specifications download pdf (Page 90)

NOTICE

Due to the lower roll offset, clearance at the left side

will be slightly less than the clearance at the mid-

dle, and clearance at the right side will be greater.

7. If adjustment is necessary, take the following

steps.

a. Raise the conveyor.

b. Block and support the conveyor.

c. With the pistons of the conveyor lift cylin-

ders (Figure SP-20) retracted, remove the

snap ring at the bottom of each cylinder,

and remove both cylinders.

d. Add or remove an equal number of shim

washers at the rod end of each cylinder. An

equal number is used to maintain conveyor

squareness.

e. Install the cylinders and snap rings.

f. Unblock and lower the conveyor.

g. Repeat the clearance checking procedure.

SERVICE

PROCEDURES

SP-24

STOP BOLT LIFT CYLINDER

Left Side Of Conveyor

Figure SP-20

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 111 112

No comments

Elgin Pelican P Specifications Page 90