Elgin Pelican P Specifications download pdf (Page 69)

NOTICE

Hydrostatic drive system must not be operated with

either tow pin in “tow” position (the inner position).

Damage to shaft and splines may result.

4. At each drive wheel, take the following steps.

a. Carefully remove two screws and discon-

nect cover from hub (Figure SP-1) to let

tow pin move out and engage hub.

NOTICE

If a tow pin does not pop out, it can be

made to do so by rocking the sweeper back-

ward and forward or by jacking up the

front of the sweeper and turning the drive

wheel. If a jack must be used, see Wheels

And Tires in this section of the manual.

b. Reverse disconnect cover, so it will hold

tow pin in outer position.

c. Secure cover with screws.

WARNING

Make sure sweeper will not roll out of control,

before you unblock the wheels.

5. Unblock wheels.

AIR CLEANER

The engine is equipped with a dual-element, dry-

type air cleaner with an automatic rubber unloader

(dump) valve (Figure SP-2). A sensor in the air

cleaner signals when air flow is restricted, causing

the air filter restriction indicator to light on the

control console. This indication alerts the operator

that the air filter needs servicing.

NOTICE

Do not open the air cleaner unless the indicator

lights or weak engine performance suggests a lack of

air supply.

To service the air cleaner, use the following

procedure:

SP-3

SERVICE

PROCEDURES

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 111 112

No comments

Elgin Pelican P Specifications Page 69